How to Install the ArkKVM ATX Power Control Board
The ArkKVM ATX Power Control Board lets you remotely control your PC’s power and reset functions and monitor its power and HDD status.
Your PC’s original front-panel buttons and LEDs will continue to work normally.
What’s in the Box
1. Prepare the ATX Board
Step 1 — Attach the Mounting Bracket
Choose the mounting bracket that matches your PC/server’s expansion slots.
Secure the ATX board to the bracket using the included screws.
Step 2 — Connect the Front-Panel Jumper Cable
Connect the multi-pin end of the front-panel jumper cable to the lower row of pins on the ATX board. Note the wire color corresponding to each label on the board.
Note: Both rows of pins provide the same functions. We recommend using the lower row for the jumper cable, leaving the upper row available for your PC’s original front-panel connectors.
2. Connect the ATX Board to the Target PC/Server
Step 3 — Power Off and Open Your PC
Shut down your PC/server, disconnect the power cord, and remove the side panel to access the motherboard.
Step 4 — Locate the Front-Panel Header
Locate the front-panel header on the motherboard. It is commonly labeled F_PANEL, PANEL, JFP1, or similar.
Note: Refer to your motherboard manual for the exact pinout, as the layout varies between models.
Step 5 — Connect the Jumper Wires
Disconnect the original front-panel cables from the motherboard. Then connect the jumper wires from the ATX board to the corresponding pins on the motherboard, one by one.
Important: Match the polarity (+/−) of each connection. Some motherboards may not clearly indicate the polarity of the Power and Reset pins. If either function does not work during testing, power off and unplug the PC, reverse the corresponding connector, and try again.
Step 6 — Reconnect the Original Front-Panel Cables
Connect the PC/server’s original front-panel cables to the corresponding pins on the ATX board.
Note: “SW” (Switch) on the original cables corresponds to “BTN” (Button) on the ATX board. Make sure the Power LED and HDD LED connections have the correct polarity (+/−).
Step 7 — Install the ATX Board
Install the ATX board in an available expansion slot at the rear of the PC/server, then secure the bracket with a screw.
3. Connect the ATX Board to ArkKVM
Step 8 — Connect the RJ12 Cable
Connect the ATX board to ArkKVM’s Extension port using the included RJ12 cable.
Note: The USB-C port provides an optional external power input for the ATX board and ArkKVM. For normal ATX power control, you do not need to connect a USB-C cable.
4. Test the ATX Power Control
Step 9 — Test the Connection
Open the ArkKVM Web UI and click ATX Power in the toolbar.
You can now remotely control your PC’s power and reset functions and monitor its power and HDD activity.
Note: The Power button also supports a long-press operation.
5. Important Notes
⚠️ Warning — RJ12 Cable Replacement
Use the included RJ12 cable. If you need a longer or replacement cable, make sure it is a 6P6C straight-through cable (pin-to-pin wiring).
*Using a cable with a different pinout may damage your ArkKVM or ATX board.
Straight-Through Wiring (Correct) Reversed Wiring (Incorrect)
Compare both connectors with the locking tabs facing the same direction.